Mopar Performance - PT CRUISER


	TURBO UPGRADE KITS A. Stage 1 Turbo Upgrade Kits These Stage 1 Turbo Upgrade Packages for the PT Turbo boost power to 235 hp and 260 ft.-lbs. of torque. Key Components: • Stage 1 Performance Control Module • (4) 577 cc/min Fuel Injectors (2003 Kit only) • Upper-to-lower Intake Manifold Gasket Calibration Features — Manual Transmission (MTX) • Increased WOT and part throttle boost • Enhanced 1st gear boost schedule for a higher performance launch • Optimized calibration for the Mopar Performance Blow-Off Valve Conversion Kit (P4510548 — sold separately) • Improved turbo response • Boost hold feature during Wide Open Throttle shifts • Soft rev limiter Calibration Features — Automatic Transmission (ATX) • Increased WOT and part throttle boost • Optimized calibration for the Mopar Performance Blow-Off Valve Conversion Kit (P4510548 — sold separately) • Improved turbo response • Performance optimized transmission calibration P4510597 Stage 1 Turbo Upgrade Kit (2004 Only PT Turbo ATX) P4510606 Stage 1 Turbo Upgrade Kit (2004 Only PT Turbo MTX) P5007944 Stage 1 Turbo Upgrade Kit (2003 Only PT Turbo ATX) P5007943 Stage 1 Turbo Upgrade Kit (2003 Only PT Turbo MTX) Note: P4510597 will work with 2004 high-output and low-output (180 hp) ATX models. Cat-Back Exhaust (P4510463) is recommended. B. Blow-Off Valve Conversion Kit The Mopar Performance Blow-Off Valve Conversion Kit maximizes the function of your vehicle’s turbo system by venting excess hot compressed air into the atmosphere, thereby reducing your intake air temperature. This kit adds a vent to the stock blow-off valve and creates a unique turbo sound. * P4510548 Blow-Off Valve Conversion Kit-Anodized, Blue (2003–05 SRT4, 2003–05 PT Turbo) CAMSHAFT COMPONENTS C. Hydraulic Lash Adjusters Use these high-performance Hydraulic Lash Adjusters for improved hydraulic lash control. They are resistant to aeration. Sold in sets of 4 (2 sets required per engine). P5007440 Hydraulic Lash Adjusters (1995–99 Neon DOHC, 2.4L DOHC Engines) Note: 2.4L engines found in the following vehicles: Minivan, Stratus/ Sebring Sedan/Breeze/Cirrus, Sebring Convertible, Stratus Coupe/Sebring Coupe and PT Cruiser.
IGNITION AND ELECTRONICS A. Ignition Wire Set — 7.5 mm, Pre-cut This special, high-performance 7.5 mm plug wire set is speciﬁcally designed to maintain compatibility with the onboard computers and electronics found on production vehicles. Each package contains the high tech style boot ends at both the distributor and plug ends of the wire. These blue wires are imprinted with the Mopar Performance name as well as the cylinder number. P4876511 Ignition Wire Set (Neon, PT Cruiser and 2.4L Stratus DOHC) B. Spark Plugs These 2.0L/2.4L Bosch Motorsports spark plugs are speciﬁcally designed for the optimum performance of your engine. Package contains 4 Spark Plugs. P4876923 Spark Plugs-Cross Reference Number RC9YC (Neon, USA 2.4L Engines) Note: 2.4L engines include Minivan, Stratus/Sebring Sedan/Breeze/Cirrus, Sebring Convertible, Stratus Coupe/Sebring Coupe, and PT Cruiser. VALVE COVERS C. NEW! Carbon Fiber Valve Cover Add even more excitement under your hood with a carbon ﬁber valve cover. Mopar Performance’s injection-molded carbon ﬁber valve covers offer great sealing performance using stock seal and anodized 6061 aluminum ﬁttings. Twill woven materials give the valve covers a stunning carbon ﬁber look. These are the lightest valve covers that can be made without sacriﬁcing the structural integrity necessary for race cars and high-performance street machines. P4510538 Carbon Fiber Valve Cover (2003–05 SRT4, 2003–05 PT Turbo) D. NEW! Valve Covers These hot looking Valve Covers can bring car show quality to your SRT4 or PT Turbo. Available in a variety of colors, these Mopar Performance valve covers can bring that ﬁnal touch of class to your high-performance vehicle. P4510371 Electric Blue Powder-Coated Valve Cover (2003–05 SRT4, 2003–05 PT Turbo) P4510367 Red Powder-Coated Valve Cover (2003–05 SRT4, 2003–05 PT Turbo) P4510368 Yellow Powder-Coated Valve Cover (2003–05 SRT4, 2003–05 PT Turbo) P4510370 PermastarTM Chrome Valve Cover (2003–05 SRT4, 2003–05 PT Turbo)
SUSPENSION UPGRADES The Stage 1, 2 and 3 Mopar Performance Suspension Components were produced by a team of Mopar and KW Suspension engineers using DaimlerChrysler specs, logging hundreds of hours of real world and track testing time to ensure optimal performance. A. NEW! Stage 1 Anti-Sway Bars Anti-Sway Bars from Mopar Performance are made from high-quality bar material that ensures durability and heightens performance, ride and handling by virtually eliminating body roll, helping to keep all four tires ﬁrmly on the pavement. P4510261 Stage 1 Anti-Sway Bar Kit — 25.4 mm Front, 19 mm Rear (2001–05 PT Cruiser Non-Turbo) P4510455 Stage 1 Anti-Sway Bar Kit — 27 mm Diameter Front, 19 mm Diameter Rear (2003–05 PT Turbo) P4510839 Stage 1 Sway Bar Installation Kit (2001–05 PT Cruiser) Note: Customers who do not currently have a rear sway bar must also purchase the Sway Bar Installation Kit (P4510839). B. NEW! Stage 1 Performance Springs These Performance Springs are made of high-tensile spring material that ensures durability and heightens spring performance without bind. P4510262 Stage 1 Performance Springs-22 mm Front Drop, 18 mm Rear Drop (2003–05 PT Turbo) P4510459 Stage 1 Performance Springs-20 mm Front Drop, 18 mm Rear Drop (2001–05 PT Cruiser Non-Turbo) C. NEW! Stage 2 Coilover Suspension Kits Get ready for a whole new level of performance from your PT. The new Stage 2 Coilover Suspension Kit for the PT Cruiser and PT Turbo is the ultimate in performance and ride for your PT. It will provide your vehicle with better handling and ride characteristics than any other aftermarket suspension system available today! The lowering range has been optimized for the PT Cruiser platform, allowing you to set the height anywhere from factory height to 40 mm lower on the front, with a preset lowering of 57 mm on the rear. Features: • Easy-adjust stainless steel-impregnated composite perches • Stock height and down lowering range • High-quality, high-tensile racing springs • Special ventilation and sealing system • Hardened chromium-plated piston rods • Pistons with V-shaped Teﬂon seals • Strut and shock housings in INOX-line stainless steel P4510448 Stage 2 Coilover Suspension Kit (2001–05 PT Cruiser Non-Turbo) P4510449 Stage 2 Coilover Suspension Kit (2003–05 PT Turbo)
INOX Technology Stage 2 and 3 Kits feature new INOX Stainless Steel technology exclusive to Mopar Performance and KW Suspensions. After 418 hours of testing (salt water spray), INOX Coilover Suspension Struts constructed of stainless steel were clearly superior to the galvanized versions in terms of corrosive resistance, and were still functioning perfectly after testing.
A. NEW! Stage 3 Coilover Suspension Kits “The Mopar Stage 2 and 3 equipped PT Cruiser and PT Turbo have exhibited the most dramatic change of any of the vehicle platforms. With the addition of this system, the vehicle balance, roll stiffness, and front to rear transition have been exponentially improved, while actually adding additional driving comfort! One drive and you are hooked. . . . And the look is just right. This is exactly what the designers had intended. A must have. Incredible!”- Mopar/KW Engineering Team The Stage 3 Coilover Kit includes all the features of the Stage 2 Kit. In addition, the Stage 3 Kit allows drivers to adjust the damper setting of the suspension system for the ultimate in personalization. The adjustable rebound damper gives drivers the ability to adjust the vehicle’s pitch and roll to their driving preferences and needs, from the street to the track. The Stage 3 Kit is height adjustable and rebound adjustable from 20% under to 50% over Stage 2 settings. Rebound adjustment takes place via an adjustment screw at the end of the piston rod, and primarily affects the low and midrange rebound dampening. Features: • External adjustable rebound damper • Stock height and down lowering range • Easy-adjust stainless steel impregnated composite perches • High-quality, high-tensile racing springs • Special ventilation and sealing system • Hardened chromium-plated piston rods • Pistons with V-shaped Teﬂon seals • Strut housings in INOX-line stainless steel P4510628 Stage 3 Coilover Suspension Kit (2003–05 PT Turbo) P4510629 Stage 3 Coilover Suspension Kit (2001–05 PT Cruiser Non-Turbo)
	AIR SYSTEMS A. Cold Air Intake System These bolt-on systems are designed to allow cooler outside air through a directional cone ﬁlter and funnel directly into the intake manifold. These kits provide noticeable horsepower and torque gains under varying atmospheric conditions. Kits include all mounting hardware and a pre-oiled, washable/reusable ﬁlter. P5007832 Cold Air Intake System (2001–03 PT Cruiser Non-Turbo) B. Air Filter Mopar Performance Air Filters are constructed with factory tight seals, engineering level polyurethane, deep 4-ply pleats of oiled cotton gauze, and 2-layer screen. This ﬁlter offers high ﬂow and low restriction, better throttle response and increased ﬁltration and horsepower. Filters are washable and reusable and come pre-oiled. P4510476 Air Filter (2001–04 PT Cruiser Non-Turbo)* EXHAUST SYSTEMS C. Cat-Back Exhaust Systems Exhaust Systems feature T304 stainless steel construction (aircraft quality) with mandrel-bent tubing, stainless band (torca) clamps and polished tips. These free-ﬂow systems provide a horsepower and torque gain, improved fuel economy and a deeper tone. P4510463 Cat-Back Exhaust — 3.50" Round Tips, Dual-Split Outlet (2003–04 PT Turbo) P5007748 Cat-Back Exhaust-3.50" Round Tips, Dual-Split; U.S. Mufﬂer (2001–04 PT Cruiser Non-Turbo) P5007457 Cat-Back Exhaust-Twin Chrome 2.00" DTM Tips, Driver Side Outlet (2001–04 PT Cruiser Non-Turbo) P5007746 Cat-Back Exhaust-Dual-Split, Large European Mufﬂer, Stock Noise (2001–05 PT Cruiser Non-Turbo) TRANSAXLE COMPONENTS D. Limited Slip Differential Quaife automatic torque-biasing Limited-Slip Differential improves handling and steering, and powers both drive wheels under nearly all conditions. Internal components sense which wheel has better grip and biases more power to that wheel. P5007382 Limited-Slip Differential (2001–05 Neon T-350 MTX and PT Cruiser Non-Turbo) E. NEW! Hurst Short-Throw Shifters These Short-Throw Shifters for the PT Cruiser enhance performance by providing shorter, quicker shifts and reducing knob travel by 30%. Custom designed to eliminate any vehicle modiﬁcations when installing. Positive gear stops eliminate overshifting, helping prevent transmission and cable damage. Includes urethane bushings to eliminate mounting bracket ﬂex providing a more positive and secure shifting feel. CNC-machined billet steel gear selector and billet aluminum stop collar provide ultimate strength. Classic Hurst appearance and feel ﬁts perfectly in the “retro” PT Cruiser. P4510486 Hurst Short-Throw Shifter (2003-05 PT Turbo) P4510263 Hurst Short-Throw Shifter (2001-05 PT CruiserNon-Tubo)